CROSS Safety Report
Cladding fixed to stainless steel
This report is over 2 years old
Cladding panels fixed to a stainless steel supporting angle with stainless steel screws failed.
Key Learning Outcomes
For civil and structural design engineers:
Connections can often be the weak link in structures and attention to detail is required
Careful consideration is required for connections, particularly at interfaces between different materials. The role of tolerances should not be overlooked
Find out more about the Full Report
Our secure and confidential safety reporting system gives professionals the opportunity to share their experiences to help others. If you would like to know more, please visit the reporting to CROSS-AUS page.
A problem occurred with the failure of some cladding panels fixed to a stainless steel supporting angle with stainless steel screws. According to the reporter stainless steel strain hardens very rapidly and self-tapping screws bind up. On this occasion large pilot holes had been drilled and the screws were so loose that they unwound with air pressure fluctuations on the cladding allowing the cladding panels to fall off.
Expert Panel Comments
Find out more about the Expert Panel
An Expert Panel comment on the reports we receive. They use their experience to help you understand what can be learned from the reports. If you would like to know more, please visit the CROSS-AUS Expert Panel page.
CROSS has previously received reports on problems with stainless steel in structural situations and further examples will be welcome.
Share your knowledge
Your report will make a difference. It will help to create positive change and improve safety.
Our secure and confidential safety reporting system gives professionals the opportunity to share their experiences to help others.
No feedback has yet been published for this page.