CROSS UK Logo
Menu

Safety information search results

Filter your results

Content type

756 results
Reset filters

Painted faying surfaces leads to connections with insufficient load capacity

Painted, rather than the required unpainted connection faying surfaces, were identified by the Resident Engineer of a reporter's firm during the erection of a primary frame for a large project. The painted surfaces resulted in the connections not having sufficient load carrying capacity and necessitated remedial works.

20 November 2023

CROSS Safety Report

Report ID: 896

Region: CROSS-UK

Provision of water for firefighting

A reporter suggests that there is inadequate guidance on firefighting water provision for more complex and larger buildings.

20 November 2023

CROSS Safety Report

Report ID: 1204

Region: CROSS-UK

Fire protection to structure by cavity barriers

A reporter is concerned about a potential misconception in the construction industry regarding the role of cavity barriers and the impact their design and installation can have on the structural performance of a building.

20 November 2023

CROSS Safety Report

Report ID: 1231

Region: CROSS-UK

The stack effect and considerations for smoke control

A reporter believes real-world tests demonstrate that existing smoke control systems may not suitably account for typical winter stack effect conditions.

20 November 2023

CROSS Safety Report

Report ID: 1250

Region: CROSS-UK

Failure of Firefighters lift to operate

The reporter tells of an instance when a Firefighters lift switch, located on the Fire Service Access Level (FSAL) in a multi-storey building failed to operate. After an investigation the switch was found not to have been connected.

20 November 2023

CROSS Safety Report

Report ID: 1232

Region: CROSS-UK

Serious inconsistencies when installing passive fire protection

An onsite fire engineer, engaged on behalf of the end client during the construction of a new residential development, reports a significant amount of inadequately installed passive fire protection elements.

20 November 2023

CROSS Safety Report

Report ID: 1199

Region: CROSS-UK

Fire performance of timber cladding

This report relays a concern that guidance to The Building Regulations 2010 regarding the use of timber cladding may be the result of a misinterpretation.

20 November 2023

CROSS Safety Report

Report ID: 1194

Region: CROSS-UK

Installation of epoxy resin adhesive for reinforcing bar anchors

Potentially dangerous installation of resin-anchored reinforcing bars, where epoxy resin was applied at the top of the hole after bars had been inserted.

7 November 2023

CROSS Safety Report

Report ID: 1225

Region: CROSS-AUS

Risk of failure of untested vibration isolators with seismic restraint

Risk of failure of vibration isolators with integral seismic restraint being used without independent third party testing

7 November 2023

CROSS Safety Report

Report ID: 1230

Region: CROSS-AUS

Incorrect use of software for wind loads on solar panels

A reporter is concerned about designers relying completely on the output of software for structural analysis when they do not fully understand the requirements for data input.

7 November 2023

CROSS Safety Report

Report ID: 1212

Region: CROSS-AUS

Submit a report

Your report will make a difference. It will help to create positive change and improve safety.

Our secure and confidential safety reporting system gives professionals the opportunity to share their experiences to help others.

Find out more